B0mBz - Miscellaneous - http://maxpages.com/wickedjuggalo/Bombs

I would just like to say, I take no responsibility in the uses of this information, and that all the information on this page is for educational perposes.

Diskette Bombs

You need:

- A disk
- Scissors
- White or blue kitchen matches (they MUST be these colors!)
- Clear nail polish

- Carefully open up the diskette (3.5" disks are best for this!)

- Remove the cotton covering from the inside.

- Scrape a lot of match powder into a bowl (use a wooden scraper,
metal might spark the matchpowder!)

- After you have a lot, spread it evenly on the disk.

- Using the nail polish, spread it over the match mixture

- Let it dry

- Carefully put the diskette back together and use the nail polish
to seal it shut on the inside (where it came apart).

- When that disk is in a drive, the drive head attempts to read
the disk, which causes a small fire (ENOUGH HEAT TO MELT THE DISK
DRIVE AND FUCK THE HEAD UP!!). ahahahahaha! Let the fuckhead try
and fix THAT!!!

Tennis Ball Bombs

Ingredients:

- Strike anywhere matches
- A tennis ball
- A nice sharp knife
- Duct tape

Break a ton of matchheads off. Then cut a SMALL hole in the tennis
ball. Stuff all of the matchheads into the ball, until you can't
fit any more in. Then tape over it with duct tape. Make sure it is
real nice and tight! Then, when you see a geek walking down the
street, give it a good throw. He will have a blast!!

How to make a fertilizer bomb

Ingredients:

- Newspaper
- Fertilizer (the chemical kind, GREEN THUMB or ORCHO)
- Cotton
- Diesel fuel

Make a pouch out of the newspaper and put some fertilizer in it.
Then put cotton on top. Soak the cotton with fuel. Then light and
run like you have never ran before! This blows up 500 square feet
so don't do it in an alley!!

Mail Box Bombs by the Jolly Roger

(1) Two litre bottle of chlorine (must contain sodium hypochlorate)

Small amount of sugar

Small amount of water

Mix all three of these in equal amounts to fill about 1/10 of the
bottle. Screw on the lid and place in a mailbox. It's hard to
believe that such a small explosion will literally rip the mailbox
in half and send it 20 feet into the air! Be careful doing this,

though, because if you are caught, it is not up to the person
whose mailbox you blew up to press charges. It is up to the city.

Smoke Bombs

Here is the recipe for one helluva smoke bomb!

4 parts sugar
6 parts potassium nitrate (Salt Peter)

Heat this mixture over a LOW flame until it melts, stirring well.
Pour it into a future container and, before it solidifies, imbed a
few matches into the mixture to use as fuses. One pound of this
stuff will fill up a whole block with thick, white smoke!

Paint Bombs

To make a pain bomb you simply need a metal pain can with a
refastenable lid, a nice bright color paint (green, pink, purple,
or some gross color is perfect!), and a quantity of dry ice. Place
the paint in the can and then drop the dry ice in. Quicky place
the top on and then run like hell! With some testing you can time
this to a science. It depends on the ratio of dry ice to paint to
the size of the can to how full it is. If you are really pissed
off at someone, you could place it on their doorstep, knock on the
door, and then run!! Paint will fly all over the place HAHAHA!!

Letter Bombs

- You will first have to make a mild version of thermite. Use my
recipe, but substitute iron fillings for rust.

- Mix the iron with aluminum fillings in a ratio of 75% aluminum
to 25% iron. This mixture will burn violently in a closed space
(such as an envelope). This bring us to our next ingredient...

- Go to the post office and buy an insulated (padded) envelope.
You know, the type that is double layered... Seperate the layers
and place the mild thermite in the main section, where the letter
would go. Then place magnesium powder in the outer layer. There is
your bomb!!

- Now to light it... this is the tricky part and hard to explain.
Just keep experimenting until you get something that works. The
fuse is just that touch explosive I have told you about in another
one of my anarchy files. You might want to wrap it like a long
cigarette and then place it at the top of the envelope in the
outer layer (on top of the powdered magnesium). When the touch
explosive is torn or even squeezed hard it will ignite the
powdered magnesium (sort of a flash light) and then it will burn
the mild thermite. If the thermite didn't blow up, it would at
least burn the fuck out of your enemy (it does wonders on human
flesh!).

How to make a CO2 bomb by the Jolly Roger

‡You will have to use up the cartridge first by either shooting it
or whatever. With a nail, force a hole bigger so as to allow the
powder and wick to fit in easily. Fill the cartridge with black
powder and pack it in there real good by tapping the bottom of the
cartridge on a hard surface (I said TAP not SLAM!). Insert a fuse.
I recommend a good water-proof cannon fuse, or an m-80 type fuse,
but firecracker fuses work, if you can run like a black man runs
from the cops after raping a white girl.) Now, light it and run
like hell! It does wonders for a row of mailboxes (like the ones
in apartment complexes), a car (place under the gas tank), a
picture window (place on window sill), a phone booth (place right
under the phone), or any other devious place. This thing throws
shrapnel, and can make quit a mess!!

Exploding lightbulbs

Materials needed:

-lightbulb (100w)
-socket (duh...)
-1/4 cup soap chips
-blackpowder! (open some shotgun shells!)
-1/4 cup kerosene orgasoline
-adhesive tape
-lighter or small blowtorch
-glue

Procedure for a simple exploding lightbulb:
~

- Drill a small hole in the top of the bulb near the threads!

- Carefully pour the blackpowder into the hole. Use enough so
that it touches the filament!

- Insert into socket as normal (make sure the light is off or
else YOU will be the victim!!)

- Get the hell out!!

Hindenberg Bomb

Needed:1 Balloon
1 Bottle
1 Liquid Plumr
1 Piece Aluminum FoilL
1 Length Fuse

Fill the bottle 3/4 full with Liquid Plumr and add a little piece of
aluminum foil to it. Put the balloon over the neck of the bottle until
the balloon is full of the resulting gas. This is highly flammable
hydrogen.
Now tie the baloon. Now light the fuse, and let it rise.
When the fuse contacts the balloon, watch out!!!

Calcium Carbide Bomb

This is EXTREMELY DANGEROUS. Exercise extreme caution.... Obtain some
calcium carbide. This is the stuff that is used in carbide lamps and
can be found at nearly any hardware store. Take a few pieces of this

stuff (it looks like gravel) and put it in a glass jar with some
water. Put a lid on tightly. The carbide will react with the water to
produce acetylene carbonate which is similar to the gas used in
cutting torches. Eventually the glass with explode from internal
pressure. If you leave a burning rag nearby, you will get a nice
fireball!

How to Make Dynamite

Dynamite is nothing more than just nitroglycerin and a stablizing
agent to make it much safer to use. For the sake of saving time, I
will abbreviate nitroglycerin with a plain NG. The numbers
are percentages, be sure to mix these carefully and be sure to use the
exact amounts. These percentages are in weight ratio, not volume.

no. ingredients amount
---------------------------------------
#1 NG 32
sodium nitrate 28
woodmeal 10
ammonium oxalate 29
guncotten 1
#2 NG 24
potassium nitrate 9
sodium nitate 56
woodmeal 9
ammonium oxalate 2
#3 NG 35.5
potassium nitrate 44.5
woodmeal 6
guncotton 2.5
vaseline 5.5
powdered charcoal 6
#4 NG 25
potassium nitrate 26
woodmeal 34
barium nitrate 5
starch 10
#5 NG 57
potassium nitrate 19
woodmeal 9
ammonium oxalate 12
guncotton 3
#6 NG 18
sodium nitrate 70
woodmeal 5.5
potassium chloride 4.5
chalk 2
#7 NG 26
woodmeal 40
barium nitrate 32
sodium carbonate 2
#8 NG 44
woodmeal 12
anhydrous sodium sulfate 44
#9 NG 24
potassium nitrate 32.5
woodmeal 33.5

ammonium oxalate 10
#10 NG 26
potassium nitrate 33
woodmeal 41
#11 NG 15
sodium nitrate 62.9
woodmeal 21.2
sodium carbonate .9
#12 NG 35
sodium nitrate 27
woodmeal 10
ammonium oxalate 1
#13 NG 32
potassium nitrate 27
woodmeal 10
ammonium oxalate 30
guncotton 1
#14 NG 33
woodmeal 10.3
ammonium oxalate 29
guncotton .7
potassium perchloride 27
#15 NG 40
sodium nitrate 45
woodmeal 15
#16 NG 47
starch 50
guncotton 3
#17 NG 30
sodium nitrate 22.3
woodmeal 40.5
potassium chloride 7.2
#18 NG 50
sodium nitrate 32.6
woodmeal 17
ammonium oxalate .4
#19 NG 23
potassium nitrate 27.5
woodmeal 37
ammonium oxalate 8
barium nitrate 4
calcium carbonate .5

Fuse Ignition Bomb

A four strand homemade fuse is used for this. It burns like fury.
It is held down and concealed by a strip of bent tin cut from a can.
The exposed end of the fuse is dipped into the flare igniter. To use
this one, you light the fuse and hold the fire bomb until the fuse has
burned out of sight under the tin. Then throw it and when it breaks,
the burning fuse will ignite the contents.

Generic Bomb

1) Aquire a glass container
2) Put in a few drops of gasoline
3) Cap the top
4) Now turn the container around to coat the inner surfaces and then
evaporates
5) Add a few drops of potassium permanganate (<-Get this stuff from a snake bite kit) 6) The bomb is detonated by throwing aganist a solid object. *AFTER THROWING THIS THING RUN LIKE HELL THIS THING PACKS ABOUT 1/2 STICK OF DYNAMITE* Carbon-Tet Explosive A moist explosive mixture can be made from fine aluminum powder combined with carbon tetrachloride or tetrachloroethylene. This explosive can be detonated with a blasting cap. Material Required Source ----------------- ------ Fine aluminum bronzing powder Paint store Carbon Tetrachloride Pharmacy, or fire or extinguisher fluid tetrachloroethylene Dry cleaners, pharmacy Stirring rod (wood) Mixing container (bowl, bucket, etc.) Measuring container (cup, tablespoon, etc.) Storage container (jar, can, etc.) Blasting cap Pipe, can or jar Procedure: --------- 1) Measure out two parts aluminum powder to one part carbon tetrachloride or tetrachlorethylene liquid into mixing container, adding liquid to powder while stirring with the wooden rod. 2) Stir until the mixture becomes the consistency of honey syrup. CAUTION: Fumes from the liquid are dangerous and should not be inhaled. 3) Store explosive in a jar or similar water proof container until ready to use. The liquid in the mixture evaporates quicky when not confined. NOTE: Mixture will detonate in this manner for a period of 72 hours. How to Use: ---------- 1) Pour this mixture into an iron or steel pipe which has an end cap threaded on one end. If a pipe is not available, you may use a dry tin can or glass jar. 2) Insert blasting cap just beneath the surface of the explosive mix. ‡NOTE: Confining the open end of the container will add to the effectiveness of the explosive. >

Sign Guestbook

View Guestbook

dimebag@cannibismail.com

Visitors: 02263

Page Updated Sun Jan 30, 2000 8:54pm EST